Midea Group - ChinaDCL has been our partner and supplier for over 6 years. Their electric actuators are used to drive our guide vane of our refrigeration compressors. Our central air conditioners are serviing customers in HVAC all around the world with DCL's products. They continuously provide very reliable products and very ontime service to support us.
Valve Solution Inc. - USADCL has been our ODM/OEM plant for about ten years. Their products are designed per UL and CSA standard and passed CSA certification. Very few Chinese manufacturers can produce USA's standard electric actuaotrs with such good quality, that is why we choose them as our long term partner. We are expecting DCL can keep innovation.
WESA Armaturen GmbH - GermanyWith 15 years cooperation with DCL, we are very satified with DCL's products. DCL regards quality first and their employees are very rigorous to products. They always do many experiments and tests to confirm their new designs and upgrade. We are also amazing about their wonderful quality control for the outsourcing parts.
IP67 Waterproof 600Nm 90W Explosion Proof Valve Actuator
|Type||On-off, Modulating||Protection Class||IP67|
|Ambient Temperature||-20℃~+60℃||Motor Power||40W/70W/90W|
|Medium||Gas/Oil/Water/Other||Material Of Seal Surface||Soft Sealed|
|Rated Current||0.29A~8.0A||Connection Form||Flange|
90W Explosion Proof Valve Actuator,
IP67 Explosion Proof Valve Actuator,
600Nm Explosion Proof Electric Actuator
600Nm 90W Explosion proof valve actuator IP67,waterproof ISO5211 direct installation
- 360° turn for 600Nm and 90° for other torque
- Fully enclosed squirrel-cage asynchronous motor with F-class insulation rating
- Auto reset thermal switch embedded in the motor winding – trips
- Rugged IP68 and type 4X aluminum alloy with thermally bonded polyester coating
- Explosion proof grade ExdIIBT4 for ATEX/Zone system and Group C, D T4 for Division system
- Self-locking all metal gear train
- Two auxiliary limit switches to confirm valve position
- Manual override with handwheel or wrench
- CSA certification per UL and CSA standard/ATEX/CE/RoHS 3.0/SIL 3
DCL explosion proof electric actuators are widely used for explosive gases environment. High temperature may ignite the flammable gases out of actuator. T4 grade requires the highest enclosure outside surface’s temperature must be less than 135℃(300F), in whatever conditions. Considering a buffer for errors may happen, the temperature set for motor power down is 125℃(282F). PTC overheat protector is embedded in the motor winding-trips, where is the highest temperature rise part of whole actuator, instead of out of motor, to 100% ensure outer surface temperature will not go beyond required T4 grade.
On the other hand, motor must be proper designed and quality controlled. Motor’s power, wire diameter, number of coil turns, magnet material and capacitance connect to motor will influence the motor’s temperature rise. So professional actuator manufacturer must design its own motors with specifications that can best match with its gear drives. General motor will cause frequently power off with heavy duty rate and can hardly satisfy explosion proof requirements for temperature
|Turning Angle||0～90° Adjustable|
|Available Control Circuit||Type of A,B,C,D,E,F,G,H,|
|Withstand Voltage Class||DC24V: 500VAC 1 minute,AC110V/AC220V: 1500VAC 1 minute,AC380V: 1800VAC 1 minute|
|Installation Angle||360° at any angle|
|Electric Interface||2-M20×1.5explosion-proof plug,clients should install corresponding explosion-proof cable connector when using according to the cable selected.|
|Optional Function||Over-torque Protector/Heater|